Well Pump Repair in San Antonio
Pulling a pump is the expensive part of any well repair, and on a Hill Country Trinity well at 600 feet it can be most of the bill. That makes correct diagnosis worth real money — a large share of "dead pump" calls turn out to be a $200 switch or a failed pressure tank.
Diagnose in this order
- Breaker and pressure switch. Burned or pitted contacts are the single most common cause of no water, and the cheapest to fix.
- Pressure tank. Tap it. A tank that sounds solid all the way up is waterlogged. That causes rapid cycling and destroys pumps, so replacing the pump without the tank means replacing the pump twice.
- Listen at the wellhead. A pump that runs but delivers nothing usually means a dropped pipe, a failed check valve, or a water level below the intake.
- Then pull. If the motor is genuinely dead, replace it while the rig is on site.
What repairs cost
| Repair | Cost |
|---|---|
| Pressure switch | $150–$330 |
| Control box / capacitor | $180–$460 |
| Check valve / foot valve | $280–$700 |
| Wire or splice repair | $300–$900 |
| Pull and reset | $650–$1,500 |
Deeper settings in Kendall, Bandera and Comal counties sit at the top of these ranges. See full cost detail or, if you have no water right now, start with pump not working.
Frequently Asked Questions
How do I know if my well pump is bad or something else?
Rule out the cheap causes first. A pitted pressure switch, a tripped breaker or a waterlogged pressure tank all mimic total pump failure and cost a fraction of a pull. Only after those are eliminated is pulling the pump justified.
How long does a well pump repair take?
A pressure switch or control box repair is usually under two hours. A pull and reset on a deep Trinity well at 600 to 900 feet is a half-day job with a rig, which is why depth dominates the quote.
Can I repair a well pump myself?
Pressure switches and tanks are within reach of a competent DIYer. Pulling a submersible from several hundred feet is not — it requires a rig, and a dropped pump or pipe turns a repair bill into a well-rehabilitation bill.
Request Well Pump Service
Fastest response is by phone — call 210-485-5491. Or send details below and we'll call you back.